Got all the F-1030 UHMW Bushings in place. The inboard ones weren't too much problem. The outboard ones were a bit more difficult. Per a suggestion, I used a Scotch-Brite pad to reduce the O.D. and some Boelube and pushed it through and into position. Very tight fit but it worked. Then found that I was one short of AN3-12A bolts used to bolt the Bushings into place. Arrggghhh... Scrounged one from a fellow builder and will pay him back when my order comes in from ACS. Next will be the Flap Motor installation. Will also need to plan on my POS-12 Flap Position Sensor installation.